Mahr Digimar 817 CLM - Measurement Procedures in Quick Mode

31
Mahr GmbH • Digimar 817 CLM
3.2 Start a measurement procedure in Quick Mode
The Quick Mode is a new and unique measuring
procedure patented by Mahr, which both simplifies and
accelerates measurement. The intelligent system
recognizes the desired measuring function on the
movement of the measuring carriage and starts
automatically; therefore the operator can fully
concentrate of measuring. The operator can conduct
for example chain measurements or measurement
upon several bores (e.g. calculation of a index circle)
extremely efficiently and fast!
Description / Sequence Symbols / Pictures
3.2.1 Active / deactivate Quick Mode
– Press the Quick Mode key
In the status window appears the word „QUICK“
3.2.2 Quick Mode - Switch between contacting a plane / bore
– Press the shift key on the base
– If the „Contact a plane“ is active then after „Quick“ will appear the
following symbol
– If the „Contact a bore“ is active then after „Quick“ will appear the
following symbol ( )
QUICK
MODE

 