30
Mahr GmbH • Digimar 817 CLM
3.1.4 Measuring a shaft
– Position the probe below the shaft (eccentrically)
– Press key to start the measuring procedure
– The probe will automatically travel upwards and make contact
from below
– Move the workpiece parallel to the stopping face in order to
determine the reversal point / maximum
– Acceptance of the reversal point will be confirmed by an acoustic
signal (beep)
– Position the probe above the shaft (eccentrically).
– Press the function key „Contacting a shaft from above“
– The probe will automatically travel downwards and make contact
– Move the workpiece parallel to the stopping face in order to
determine the reversal point / maximum
– Acceptance of the reversal point will be confirmed by an acoustic
signal (beep) and the results (center and diameter) will appear in
the display.
Description / Sequence Symbols / Pictures
To Next Page
Loading...
