29
Mahr GmbH • Digimar 817 CLM
3.1.3 Measuring a bore
– Position the probe in the bore (not in the center / eccentrically)
– Press key to start the measuring procedure
– The probe will automatically travel upwards; the bore is contacted
from below
– Move the workpiece parallel to the stopping face in order to
determine the reversal point / maximum
– Acceptance of the reversal point will be confirmed by an acoustic
signal (beep)
– The probe will automatically travel downwards; the bore is
contacted from above
– Move the workpiece parallel to the stopping face in order to
determine the reversal point / maximum
– Acceptance of the reversal point will be confirmed by an acoustic
signal and the results (center and diameter) will appear in the
display
Description / Sequence Symbols / Pictures
To Next Page
Loading...
