PATCH: “Robotic wobble”
In this example we will use two patch cables to create a robotic wobble sound.
Now set all controls as shown in the image on the right and connect two patch cables as shown in the image below.
The LFO 2 output is patched to the VCF CUTOFF input. Both LFO 2 and MOD EG can now control the VCF CUTOFF.
Having MOD EG in LOOP mode, causes the MOD EG to behave as an LFO. This creates a more complex modulation
signal, because the LFO 2 and MOD EG signals are adding up
MAJELLA
ENGINEERING
IMPLEX
MADE IN THE NEHTERLANDS
MAJELLA
ENGINEERING
IMPLEX
MADE IN THE NEHTERLANDS
5150.
To Next Page
Loading...