7. HANDLE WITH CARE!
7a. CONNECT PROPERLY FOR SAFE USE!
I. Use grounded power cables to connect the IMPLEXUS to a grounded (earthed) wall plug.
II. Never plug in the power cable when the Fuse Drawer (next to the power connector) is removed!
III. Do not insert mono jack (TS: Tip/Sleeve) cables to the headphone or balanced outputs.
IV. If you would like to use the IMPLEXUS outputs unbalanced (not recommended for signal integrity
purposes), please use TRS (Tip/Ring/Sleeve) jack cables!
V. Do not apply voltages to the inputs and outputs of IMPLEXUS that exceed the voltage range of +12V
or -12V.
VI. Do not apply phantom power (48V) to any of the inputs and outputs! This may or will result in damage
to your IMPLEXUS!
VII. See page 6 for instructions on how to correctly connect your IMPLEXUS.
VIII In Case a FUSE has been blown, replace with 500mA (0.5A) slow blow. In case the FUSE keeps blow-
ing, please contact support@majella-audio.com
7b. IN CASE OF AN ACCIDENT
Turn off the IMPLEXUS, keep the IMPLEXUS unplugged and immediately contact Majella Audio (at support@
majella-audio.com) when the following situations has occurred:
I. Liquid was spilled onto the IMPLEXUS.
II. The IMPLEXUS was dropped.
III. The IMPLEXUS is not functioning correctly.
IV. The IMPLEXUS enclosure was damaged.
8. TAKING CARE OFF IMPLEXUS
8a. Wipe the surfuce with a soft cloth, try to keep the IMPLEXUS free of dust.
8b. Don’t use damp cloths on the IMPLEXUS panel or wooden side panels.
8c. The wooden side panels are finished with oil, and should not wear with normal use. If wear shows one can
contact us for maintenance instructions.
9. Please feel free to contact us in case of any questions!
Email: support@majella-audio.com
Visit: www.Majella-Audio.com
To Next Page
Loading...