INDUCTANCE MEASUREMENT
WARNING: To avoid electric shock, disconnect both test probes from
any source of voltage before making a inductance measurement.
1. If you wish to measure inductance, set the function switch to the
10mH.
2. Insert the black test lead banana plug into Negative input jack for
inductance measurements and the red test lead banana plug into
Negative input jack for inductance measurements.
3. Touch the inductance Probe head to the part which inductance you
wish to measure. Keep the probe touching the part under test until
the reading stabilizes (about 10 seconds).
4. Read the temperature in the display. The digital reading will indicate
the proper decimal point and value.
WARNING: To avoid electric shock, be sure the inductance has been
removed before changing to another measurement function.
REPLACING THE BATTERY
WARNING: To avoid electric shock, disconnect the test leads from any
source of voltage before removing the battery door.
1. When the batteries become exhausted or drop below the operating
voltage, “ ” will appear in the right-hand side of the LCD
display. The battery should be replaced.
2. Follow instructions for installing battery. See the Battery Installation
section of this manual.
3. Dispose of the old battery properly.
WARNING: To avoid electric shock, do not operate your meter until the
battery door is in place and fastened securely.
To Next Page
Loading...
Need help?
General
