MAJORITY Humboldt - System Settings

11
EN
Pin (code number)
●
Press
12 w
/
s 3
button to select PIN. Press SELECT button to conrm. The radio will generate an
8-digit code number, which will be displayed on radio’s screen.
●
Refer to your router user manual to follow the WPS instructions, when using a pin code number.
Enter this code number into the wireless router to connect with Humboldt.
●
Press SELECT button to continue.
Connecting using your wireless network password
When using a router with no WPS, connect Humboldt to your wireless network using a password.
Select SKIP WPS to go to password screen.
●
Typing password. Press
12 w
/
s 3
/
7
/
8
buttons to select letter/number of your password.
Press SELECT button to enter the selected letter/number.
●
Once the password has been entered, press
12 w
/
s 3
/
7
/
8
buttons, to conrm by selecting
OK on the right hand-side of the screen. It takes a few seconds to connect with your network.
●
Press SELECT button to exit the setup.
Settings can be changed at any time in Menu-System Settings - Network - Network wizard
System Settings
Press the MENU button on unit or remote control to display the menu. Turn TUNING/SELECT dial on
unit or
12 w
/
s 3
buttons on remote control to select System settings, then press TUNING/SELECT
dial on unit or SELECT button on remote to conrm.
Equaliser
This system supports a variety of equalizers and sound eects.
●
Press the EQ button to access Equaliser menu.
●
While in ‘System Settings’, Press
12 w
/
s 3
buttons to select Equaliser ,then press the SELECT
button to conrm
1. The display will show: FLAT > CLASSIC > ROCK > POP > JAZZ
2. Press
12 w
/
s 3
buttons to select EQ mode and then press the SELECT button to conrm.
Streaming audio quality
●
While in System Settings’, Press
12 w
/
s 3
button to select ‘Streaming audio quality’. Press the
SELECT button to conrm.
●
Press
12 w
/
s 3
button to select Low quality/ Normal quality/ High quality. Press the SELECT
button to conrm the setting
Instructions Guide