Makeblock mBot Servo Pack - Page 6

08 09
Step 3
Step 4
Plate I1-Blue ×1
M4×8mm Screw ×2
M4 Nut ×2
M4×8mm Screw ×2
Me RJ25 Adapter Module ×1
Step 5
Step 6
Firstly,you should adjust servo to 90 degrees with software, then
install servo arm to the servo (pay attention to their angle).
Me Ultrasonic Sensor ×1
M4×8mm Screw ×2
M4 Nut ×2
9g Micro Servo ×1
9g Micro Servo Bracket ×1
Servo Arm ×1
M2×10mm Screw ×2
M2 Nut ×2
M2.2×6.5mm
Self-drilling Screw
×1
The ultrasonic sensor is included
in mBot.
Tip