10 11
Step 7
Step 8
Please insert self-drilling
screw through the hole
marked red.
Cuttable Linkage-Blue ×1
M2.2×8mm Self-drilling Screw ×2
Plastic Spacer 4×7×2mm ×2
M4×25mm Brass Stud ×2
M4×8mm Screw ×2
M4 Nut ×2
Step 9 Wire connections
This is the reference picture of wire connections in construction
examples. You can also change the ports according to your own
program.
Good job !
You have finished the construction.
Now you can control your Dancing
Cat according to the constructions
on page 5.
Me Line-follower Sensor
9g Micro Servo
Me Ultrasonic Sensor
Me RJ25 Adapter Module
Tip
To Next Page
Loading...
