Working with programs
•
Press
p
P appears on the display.
•
0 1
...
9 9
Enter program number.
•
Press
S
button
dimension is approached.
Insert paper and move by means of the paper
knock-up block
b
to the backgauge
I
and
side lay on the left
J
.
•
Release the cut
after every cut the
backgauge advances to the next position.
Release a cut see page 17.
Correcting a measurement
When a dimension has to be corrected during
cutting (e.g. program step 03) advance to the
new cutting position with the rotary control
Q
or enter the new dimension on the keypad
W
.
g
press, new measurement is stored
Press
S
advances to the correct dimension
Cutting is activated and the correct
measurement is cut.
Attention: the correct dimension is now
stored in the program
With the button
r
and
h
you are able to
change between several program steps.
With
S
the backgauge moves to the indicated
dimension.
With
s
the backgauge stops.
General
LED "S" on
specified dimension not
achieved.
LED "S" is off
specified dimension achieved.
Exiting program-mode
•
Press
p
P appears on the display.
•
Press
s
Escape the program mode.
•
Operation
•
To Next Page
Loading...
