3. Once prompted, cut the end of your filament to create a clean edge. You can use scissors or
wire cutters to cut a clean edge on the end of your filament. You don't want to load anything with
a bulged, twisted or sharp edge.
4. Grasp the top of the extruder assembly and push the filament into the extruder's loading tube
until you can feel the motor pulling the filament in. If you're running into a problem during this
process, unload the filament and repeat step 3. It may help to press the lever on the side of the
extruder and gently feed filament towards the hot end at this point.
To Next Page
Loading...
