Need help?Do you have a question about the Makita DHP482 and is the answer not in the manual?
General| Voltage | 18V |
|---|---|
| No Load Speed (High) | 0-1, 900 RPM |
| No Load Speed (Low) | 0-600 RPM |
| Chuck Capacity | 13mm |
| Max. Drilling Capacity in Steel | 13mm |
| Max. Drilling Capacity in Wood | 38mm |
| Max. Drilling Capacity in Masonry | 13mm |
| Max Torque (Soft) | 36Nm |
| Battery Type | Li-ion |
| Length | 198mm |
| Blows per Minute (High) | 0-28, 500 BPM |
| Blows per Minute (Low) | 0 - 9, 000 IPM |
| Weight | 1.5 - 1.8 kg |
Details the tool's model number, drilling capacities for concrete, steel, wood, and fastening capacities.
Lists no-load speed, blows per minute for high/low settings, and overall length.
Specifies the rated voltage, compatible battery cartridges, and net weight.
Describes the tool's intended functions for impact drilling, screw driving, and drilling in various materials.
Emphasizes reading all warnings and instructions, and saving them for future reference.
Guidance on using specified chargers and designated battery packs to prevent fire and injury.
Instructions for preventing short circuits, avoiding contact with ejected liquid, and handling damaged batteries.
Covers reading instructions, not disassembling, and stopping use if operating time shortens.
Advice on rinsing eyes if electrolyte contacts them and avoiding battery terminal short circuits.
Guidelines for storing battery cartridges, avoiding high temperatures, and following local disposal regulations.
Instructions for securely installing the battery cartridge until the red indicator is not visible.
Explains the system that cuts off power during overload or low battery voltage conditions.
How to start, stop, and control tool speed using the switch trigger.
How to use the reversing switch lever for clockwise and counterclockwise rotation.
Ensure the tool stops before changing direction and set lever to neutral when not in use.
Instructions for changing between high and low speed settings using the speed change lever.
Ensure the speed change lever is fully set to the correct position before operation to avoid damage.
How to select drilling, hammer drilling, or screwdriving modes using the action mode changing ring.
Ensure the mode ring is correctly aligned with the tool body marks to prevent damage.
To Next Page
