Makita DHS680 - Battery Cartridge Safety; General Battery Safety Rules

Repair
Depth guide
(1) Assemble Depth guide to Base as drawn in Fig. 10.
1. Sandwitch Depth guide between Flat washers 6,
and set them to Blade case.
3. Assemble Pipe 6 over M6x90
Cap square neck bolt through
Motor housing.
5. Tighten M6 Hex nut to
M6x90 Cap square neck bolt
with Lever 45.
7. After inserting 6-7 Shoulder pin through Flat washer 6,
pass 6-7 Shoulder pin through the holes of Depth guide
and Base. And then, fix 6-7 Shoulder pin with M5x8
Hex socket head set screw.
4. Mount Flat washer 6 on M6x90
Cap square neck bolt
Depth guide
P 7/ 18
Flat washer 6
Flat washer 6
M6x90 Cap square
neck bolt
Motor housing
2. Pass M6x90 Cap square neck bolt to Motor housing
through Blade case, two Flat washers 6 and Depth guide.
Flat washer 6
Pipe 6
M6 Hex nut
Lever 45
6-7 Shoulder pin
Flat washer 6
M5x8 Hex socket head set screw
Fig. 10
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Depth guide (cont.)
ASSEMBLING
6. Align the hole of Depth guide to that of
Base so as to pass 6-7 Shoulder pin
through the holes.