Need help?Do you have a question about the Makita DS4010 and is the answer not in the manual?
General| Power Source | Corded |
|---|---|
| Weight | 2.3 kg |
| Input Power | 570 W |
| Max. drilling capacity in steel | 13 mm |
| Cord Length | 2.5 m |
| Type | Electric Drill |
| No Load Speed | 600 RPM |
| Chuck Size | 1/2 inch (13 mm) |
| Chuck Capacity | 1.5-13 mm |
Explanation of symbols used for the equipment, including Double Insulation.
The tool is intended for drilling in wood, metal, and plastic.
Tool connected only to same voltage AC supply, operable on single-phase AC.
Typical A-weighted noise level determined according to EN60745.
Vibration total value determined according to EN60745.
Keep work area clean and lit, avoid explosive atmospheres, keep bystanders away.
Match plugs to outlets, avoid body contact with earthed surfaces, use RCD for damp locations.
Have tool serviced by qualified person, use identical replacement parts.
Explains how to start, stop, and lock the switch trigger for tool operation.
Screw the top grip onto the tool securely.
Place bit in chuck, tighten by hand and with chuck key.
Use auxiliary handle, hold firmly, avoid excessive pressure, use cutting lubricant for metals.
Check and replace worn carbon brushes regularly, use identical parts.
To Next Page
