To Next PageTo Next PageWhy is there abnormal vibration in my Makita DUC356Z?
If you experience abnormal vibration with your Makita Chainsaw, immediately stop the machine. This could be due to a loose guide bar or saw chain, requiring you to adjust the tension. Alternatively, it could indicate a tool malfunction, in which case you should seek repair from an authorized service center.
Why is Torque Boost mode not available on my Makita DUC356Z after replacing the battery?
If your Makita Chainsaw's Torque Boost mode is unavailable after replacing the battery cartridge, it may be due to usage conditions. Try using the tool in normal mode until the installed battery cartridge is empty, then replace it with a fully charged one, or simply recharge the current battery cartridge.
Why my Makita DUC356Z Chainsaw does not start?
If your Makita Chainsaw doesn't start, it might be due to several reasons. First, ensure a charged battery cartridge is correctly installed. If the battery is low, recharge it or replace it if necessary. Also, check if the main power switch is turned off, as the chainsaw automatically shuts down after inactivity. Turn the main power switch on again to resolve this.
Why my Makita Chainsaw does not reach maximum RPM?
If your Makita Chainsaw does not reach maximum RPM, the battery cartridge may be improperly installed; ensure it is correctly installed as described in the manual. Another cause could be dropping battery power, requiring you to recharge or replace the battery cartridge. If these steps do not solve the issue, the drive system may not be working correctly, and you should seek repair from an authorized service center.
Why does the motor of my Makita Chainsaw stop after a little use?
If your Makita Chainsaw motor stops running after a short period, the battery charge level is likely low. Recharge the battery cartridges, and if recharging doesn't help, consider replacing the battery cartridge.
What to do if the saw chain does not run on my Makita Cordless Saw?
The saw chain might not run because the chain brake is activated. To resolve this, release the chain brake.
How to troubleshoot a Makita Cordless Saw that does not start?
If your Makita Cordless Saw doesn't start, several factors could be at play. First, ensure a charged battery cartridge is correctly installed. If the battery is low, recharge it or replace it if recharging doesn't help. Also, check if the main power switch is off, as the saw automatically shuts down after inactivity. If so, turn the main power switch on again.
What to do if Makita DUC356Z Chainsaw has abnormal vibration?
If your Makita Chainsaw is vibrating abnormally, immediately stop the machine. This could be due to a loose guide bar or saw chain, so adjust the tension.
Why does my Makita DUC356Z motor stop running quickly?
If the motor of your Makita Chainsaw stops running after a short time, it's likely that the battery's charge level is low. Try recharging the battery cartridges. If recharging doesn't solve the issue, consider replacing the battery cartridge.
What to do if there is no oil on the chain of Makita Chainsaw?
If there's no oil on the chain of your Makita Chainsaw, the oil tank might be empty, so fill it up. Another possibility is a dirty oil guide groove, which you should clean. Also, check and adjust the oil delivery with the adjusting screw if the oil delivery is poor.
General| Battery Voltage | 36V |
|---|---|
| Bar Length | 35 cm (14 ") |
| Chain Type | 3/8" |
| Oil Tank Capacity | 0.2 L |
| Chain Gauge | 1.3 mm |
| Automatic Oiler | Yes |
| Type | Cordless |
| Chain Speed | 20 m/s |
