Makita DUR192L - Specifications

2 ENGLISH
SPECIFICATIONS
Model: DUR192L
Type of handle Loop handle
No load speed 2: 0 - 6,000 min
-1
1: 0 - 4,500 min
-1
Overall length
(without cutting tool)
1,670 mm
Nylon cord diameter 2.0 mm
Applicable cutting tool and
cutting diameter
Nylon cutting head
(P/N: 198893-8 / 191D89-4)
300 mm
Rated voltage D.C. 18 V
Net weight 2.7 - 3.0 kg
• Duetoourcontinuingprogramofresearchanddevelopment,thespecicationshereinaresubjecttochange
without notice.
• Specicationsmaydi󰀨erfromcountrytocountry.
• Theweightmaydi󰀨erdependingontheattachment(s),includingthebatterycartridge.Thelightestandheavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
Charger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
DC18SH
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
andchargersmaycauseinjuryand/orre.
Recommended battery adapter
Battery adapter PDC01
• The battery adapter(s) listed above may not be available depending on your region of residence.
• Before using the battery adapter, read instruction and cautionary markings on the battery adapter.
Noise
Cutting tool Sound pressure level (L
pA
)
dB(A)
Sound power level (L
WA
)
dB(A)
Applicable
standard
L
pA
dB(A) Uncer-
tainty (K)
dB(A)
L
WA
dB(A) Uncer-
tainty (K)
dB(A)
Nylon cutting head 74.8 0.4 87.8 1.9
ISO22868
(ISO11806-1)/
EN50636-2-91
• Even if the sound pressure level listed above is 80 dB (A) or less, the level under working may exceed 80 dB
(A). Wear ear protection.
NOTE: The declared noise emission value(s) has been measured in accordance with a standard test method and
may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may also be used in a preliminary assessment of exposure.
WARNING: Wear ear protection.
WARNING: The noise emission during actual use of the power tool can di󰀨er from the declared val-
ue(s) depending on the ways in which the tool is used especially what kind of workpiece is processed.
WARNING: Be sure to identify safety measures to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the
times when the tool is switched o󰀨 and when it is running idle in addition to the trigger time).