To Next PageTo Next PageWhat to do if the cutting attachment on my Makita ER2550LH Trimmer does not stop?
If the cutting attachment on your Makita Trimmer continues to rotate after the engine is off, the power unit may not be working correctly. Refer to the instruction manual of the power unit.
What to do if my Makita ER2550LH vibrates abnormally?
If your Makita Trimmer vibrates abnormally, stop the engine immediately. The issue might be a broken cutting attachment, in which case you should replace it. Also, check if the cutting attachment is tightened securely. Another cause could be a broken nylon cutting cord causing the nylon cutting head to become unbalanced; try feeding the nylon cutting cord by tapping the head on the ground. If the drive system isn't working properly, it's recommended to ask a Makita authorized service center to inspect and repair it.
Why won't the cutting attachment on my Makita ER2550LH Trimmer stop?
If the cutting attachment on your Makita Trimmer doesn't stop, stop the engine immediately! The power unit may not be working properly. Refer to the instruction manual of the power unit.
General| Power source | Gasoline |
|---|---|
| Cordless | Yes |
| Product color | Black, Cyan |
| Cutting diameter (max) | 412 mm |
Weight and Dimensions| Weight | 4900 g |
|---|
General guidelines for safe operation, user responsibility, and prohibited actions.
Specifies the equipment's intended purpose and limitations to prevent misuse and injury.
Details essential protective gear like helmets, eyewear, hearing protection, and gloves.
Covers pre-operation safety checks and area preparation before starting the trimmer.
Outlines critical procedures and precautions for safely fueling the machine.
Describes correct operational techniques and safe working practices.
Covers approved cutting heads, avoiding metal blades, and vibration health risks.
Briefly mentions maintenance importance and emergency first aid procedures.
Instructions for attaching the handle to the string trimmer shaft.
Guidance on installing the protective guard for safety.
Steps for securely attaching the nylon cutting head.
Procedures for checking and topping up the engine oil level.
Detailed steps for cold and warm starts, including primer pump usage.
Instructions on how to safely shut down the machine.
Guidance on adjusting the engine's idling speed via the carburetor.
How to manually feed nylon cord during operation.
Step-by-step guide for replacing worn nylon cutting cord.
Routine checks and cleaning tasks to perform daily.
Procedure for changing the engine oil, including intervals and oil type.
Instructions for cleaning the air filter element.
Guide for inspecting and adjusting the spark plug gap.
Procedure for inspecting and cleaning the fuel filter.
Recommendation for annual replacement of the fuel pipe.
Steps to drain fuel and prepare the machine for extended non-use.
Common causes and remedies for engine not starting or running poorly.
Solutions for issues like cutting attachment not rotating or abnormal vibration.
