Need help?Do you have a question about the Makita HP1640 and is the answer not in the manual?
General| Chuck type | Key |
|---|---|
| Hammer drilling | Yes |
| Idle speed (max) | 2800 RPM |
| Screw diameter (max) | 13 mm |
| Drilling diameter in wood (max) | 30 mm |
| Drilling diameter in concrete (max) | 16 mm |
| Input power | 680 W |
| Power source | AC |
Weight and Dimensions| Depth | 303 mm |
|---|---|
| Width | 72 mm |
| Height | 222 mm |
| Weight | 2000 g |
Crucial safety advice to read and understand before using the tool.
Details drilling capacities for concrete, steel, and wood.
Explains symbols used on the equipment for user understanding.
Describes the tool's purpose for impact and regular drilling operations.
Details on power connection, voltage, and double insulation.
Specifies noise levels and vibration emission values for various modes.
General safety advice and instructions for safe power tool operation.
Guidance on safe use of power tools with electrical outlets and cords.
Recommendations for operator alertness, PPE, and preventing unintentional starts.
Guidelines for proper use, maintenance, and storage of power tools.
Emphasizes using ear protection during impact drilling due to noise.
Importance of auxiliary handles, firm footing, and two-hand grip for control.
Advice on holding the tool to avoid electric shock from hidden wiring.
Guidance on keeping hands clear of moving parts and not leaving the tool running.
Caution about hot parts and handling materials with toxic chemicals.
Explains the switch trigger, lock button, and reversing switch functionality.
Instructions for turning on the built-in lamp and safety notes.
How to select between rotation with hammering and rotation only modes.
Procedure for attaching and adjusting the auxiliary side grip for safety.
Steps for inserting and removing drill bits using the chuck key.
How to set and use the depth gauge for uniform hole drilling.
Guidance on performing hammer drilling operations.
Advice on handling twisting forces, using the correct mode, and avoiding excessive pressure.
Instructions for using the optional blow-out bulb to clean holes.
Specific techniques and advice for drilling in different materials.
Guidelines for tool maintenance, emphasizing authorized service centers.
List of recommended accessories for use with the tool.
To Next Page
