Need help?Do you have a question about the Makita HP1640K and is the answer not in the manual?
General| Type | Hammer Drill |
|---|---|
| Power | 680 W |
| Chuck Capacity | 1.5 - 13 mm |
| No Load Speed | 0 - 2800 RPM |
| Amperage | 6.0 A |
| Max. Drilling Capacity (Steel) | 13 mm |
| Max. Drilling Capacity (Wood) | 30 mm |
| Max. Drilling Capacity (Concrete) | 16 mm |
| Max. Drilling Capacity (Masonry) | 16 mm |
| Vibration: Drilling into Concrete | 12.5 m/s² |
| Power Source | Corded |
| Voltage | 230 V |
| Chuck Type | Keyless |
| Chuck Size | 13 mm |
Tool for impact drilling in brick/concrete/stone and drilling in wood/metal/plastic without impact.
Connect to same voltage supply; double-insulated for use without earth wire.
Describes how to operate the switch trigger and lock button for tool activation and continuous use.
Explains the reversing switch for changing rotation direction and cautions against changing while the tool is running.
Details how to turn on the lamp by pulling the trigger and cautions against looking directly at the light.
Describes how to change the action mode lever for hammering or rotation-only modes.
Instructions for installing the auxiliary handle securely on the tool barrel for safe operation.
Guide on using the chuck key to install and remove drill bits, emphasizing hand-tightening first.
How to use the depth gauge with the side grip for drilling holes of uniform depth.
Guidance on hammer drilling in concrete, emphasizing side grip use and proper bit selection.
Tips for drilling in wood, recommending drills with guide screws for easier operation.
Techniques for drilling metal, including center-punching and using cutting lubricant.
To Next Page
