Need help?Do you have a question about the Makita HP488DWE and is the answer not in the manual?
General| Power Source | Battery |
|---|---|
| Voltage | 18V |
| Battery Type | Li-ion |
| Chuck Size | 13 mm |
| Chuck Capacity | 1.5 - 13 mm |
| No Load Speed (Lo) | 0 - 400 RPM |
| Impacts per Minute (Lo) | 0 - 6, 000 IPM |
| Max. Drilling Capacity in Steel | 13 mm |
| Max. Drilling Capacity in Wood | 36 mm |
| Max. Drilling Capacity in Masonry | 13 mm |
| Torque Settings | 16 + Drill |
| Max Torque | 42 Nm |
| Max. Fastening Torque (Hard) | 42 Nm |
| Max. Fastening Torque (Soft) | 24 Nm |
| Weight | 1.7 kg |
| Type | Cordless Hammer Drill |
Lists compatible battery cartridges and chargers for the tool.
Explains various symbols used in the manual for safety and identification.
Details noise emission levels, uncertainty, and safety precautions regarding noise exposure.
General safety advice applicable to all power tools, covering alertness, PPE, and preventing unintentional starts.
Safety guidelines for maintaining a clean, well-lit, and safe work environment.
Guidelines for proper usage, maintenance, and storage of power tools.
Instructions for safe handling, charging, and storage of battery cartridges.
Guidance on obtaining repairs and maintenance from authorized service centers.
Specific safety instructions for operating this type of tool, including impact drilling.
Crucial safety advice regarding the handling, storage, and disposal of battery cartridges.
Advice on charging and storing batteries to optimize their lifespan.
Step-by-step instructions for safely installing and removing the battery.
Explains the tool's protection system and when it activates.
Details how to operate the trigger switch for power and speed control.
Instructions on using the reversing switch to change the drill's rotation direction.
How to adjust the tool's speed settings using the speed change lever.
How to switch between drilling, hammer drilling, and screwdriving modes.
Guide on setting the torque level for screwdriving applications.
Instructions for assembling or preparing the tool before use.
Steps for securely inserting and removing drill bits and driver bits.
How to perform screwdriving tasks, including torque adjustment and pilot holes.
Guidance on performing impact drilling, including bit selection and pressure.
Describes the use of an optional accessory for cleaning dust from holes.
General instructions for drilling, including wood and metal.
Specific advice for drilling into wood materials.
Specific advice for drilling into metal materials, including lubricants.
To Next Page
