14.
F
E
I'
15.
L
16.
(
17.
$
t
18.
(
F
C
r
C
E
c
I
I'
t
19.
(
20.
F
t
I
vo
LT
outle
namc
for
tk
the
tl
voltas
IMOVE ADJUSTING KEYS AND WRENCHES. Form habit
of
checking to
!e that keys and adjusting wrenches are removed from tool before turning
on.
JOlD UNINTENTIONAL STARTING. Don't carry plugged-in tool with finger
I
switch. Be sure switch is OFF when
plugging
in.
UTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only
:tension cords intended for use outdoors and
so
marked.
TAY ALERT. Watch what you are doing, use common sense. Don't operate
01
when you are tired.
HECK DAMAGED PARTS. Before further use of the tool, a guard or other
irt that is damaged should be carefully checked to determine that
it
will
ierate properly and perform its intended function. Check for alignment of
oving parts, binding of moving parts, breakage of parts, mounting, and any
her conditions that may affect its operation. A guard or other part that
damaged should be properly repaired or replaced by an authorized serv-
e
center unless otherwise indicated elsewhere
in
this instruction manual.
we defective switches replaced by authorized service center. Don't use
01
if switch does not turn
it
on
and off.
UARD AGAINST ELECTRIC SHOCK. Prevent body contact
with
grounded
irfaces. For example; pipes, radiators, ranges, refrigerator enclosures.
!PLACEMENT PARTS. When servicing, use only identical replacement parts.
,GE WARNING: Before connecting the tool to a power source (receptacle,
etc.) be sure the voltage supplied is the same as that specified on the
)late of the tool. A power source with voltage gr.eater than that specified
!
tool can result
in
SERIOUS INJURY to the user
-
as well as damage to
01.
If
in
doubt, DO NOT PLUG IN THE TOOL. Using a power source with
e
less than the nameplate rating is harmful to the motor.
3
To Next Page
Loading...
Need help?
General
