MAINTENANCE
CAUTION
:
Always be sure that the
tool
is
switched
off
and unplugged before attempting to perform
inspection or maintenance.
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear
down
to about
4.5
mm
(3/16")
or
less.
Keep
the brushes clean and free to slip in the
holders. Both brushes should be changed
at
the same time, Use only Makita carbon
brushes.
,
.
.
.
-
-.
.
U
4.5"
(3/16")
Fig.
18
Use
a
screwdriver to remove the brush
holder cap
as
shown in the figure.
Fig.
19
Take out the worn brush, insert the new
one and secure the brush holder cap.
I I
Fig.
20
To
maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by Makita Authorized or Factory Service Center, always
using Makita replacement parts.
11
To Next Page
Loading...
Need help?
General
