ADDITIONAL SAFETY RULES
1.
Avoid cutting nails. Inspect for and remove all nails from the workpiece be-
2.
Don't cut hollow pipe.
3.
Do
not cut oversize workpiece.
4.
Check for the proper clearance beneath the workpiece before cutting
so
that
5.
Hold the tool firmly.
6.
Check the blade is not contacting the workpiece before the switch
is
turned
7.
Keep hands away from moving parts.
8.
When cutting through walls, floors or wherever "live" electrical wires may
be encountered,
DO
NOT TOUCH ANY METAL PARTS
OF
THE TOOL!
Hold the tool only by the plastic handle to prevent electric shock
if
you cut
through a "live" wire.
fore operation.
the blade will not strike the floor, workbench, etc.
on.
9.
Do
not leave the tool running. Operate the tool only when hand-held.
IO.
Always switch off and wait for the blade to come to
a
complete stop before
11.
Do
not touch the blade
or
the workpiece immediately after operation; they
removing the blade from the workpiece.
may be extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
4
To Next Page
Loading...
Need help?
General
