Makita LS1040F User Manual

2
ENGLISH (Original instructions)
SPECIFICATIONS
Model LS1040F / LS1040FS
Blade diameter 255 mm - 260 mm
Blade body thickness 1.6 mm - 2.4 mm
Hole diameter
For all countries other than European countries 25.4 mm and 25 mm
For European countries 30 mm
Max. Miter angle Left 45° , Right 52°
Max. Bevel angle Left 45°
Max. Cutting capacities (H x W) with blade 260 mm in diameter
Miter angle
Bevel angle
0° 45° (left and right)
93 mm x 95 mm 93 mm x 67 mm
0°
69 mm x 135 mm 69 mm x 95 mm
53 mm x 95 mm 49 mm x 67 mm
45° (left)
35 mm x 135 mm 35 mm x 94 mm
No load speed (min
-1
) 4,600
Dimensions (L x W x H) 530 mm x 476 mm x 532 mm
Net weight 12.6 kg
Safety class
/II
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END217-5
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
읭 Read instruction manual.
읭 DOUBLE INSULATION
읭 To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come to
a complete stop.
읭 Do not place hand or fingers close to the
blade.
읭 For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
읭 Always set SUB-FENCE to left position
when performing left bevel cuts. Failure
to do so may cause serious injury to
operator.
읭 To loosen the bolt, turn it clockwise.
읭 Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of the European Directive,
on Waste Electric and Electronic
Equipment and its implementation in
accordance with national law, electric
equipment that have reached the end of
their life must be collected separately
and returned to an environmentally
compatible recycling facility.
ENE004-1
Intended use
The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.

Makita LS1040F Specifications

General

Input power	1650 W
Power source	AC
Blade bore	30 mm
Blade diameter	255 mm
Dust bag included	Yes
Idle speed (max)	4600 RPM
Miter setting (left)	45 °
Miter setting (right)	52 °
Cutting capacity 0°	93 x 95 mm
Cutting capacity 45° miter	93 x 67 mm

Weight and Dimensions

Weight	12600 g