Makita MP001G - Inflation Settings; Setting the target pressure value; Setting the inflation mode; Hose and Air Release

10 ENGLISH


The pressure value unit is changed each time you press


-
ton. To decrease the target pressure value, press the [-]





You can select one of the three modes as follows.
Mode   

Ball


35 to 110 kPa

Low speed


speed
35 to 1,100 kPa

High speed


high speed
NOTE:


NOTE: Be sure to select the low speed mode when

-
formed properly.


󰀨
pressing the main power switch, the lamp goes out.
  Lamp  Main power switch
CAUTION: 

NOTICE: 
󰀨

NOTE:󰀨
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.




  Presta valve adapter
 Tapered adapter


  Hose holder  Hose

NOTICE: 




 
OPERATION
NOTE: The standard adapters vary depending on the
country.

NOTICE: 

-

 
 

 
 Valve stem
 Turn on the tool.
 
checking the status of the tire.
NOTICE: 


-






 
  Valve stem 
 Turn on the tool, and then set the pressure value
appropriate for the tire using the pressure gauge.
 
