9 ENGLISH
-
light up for a few seconds.
Indicator lamps
Charge the
may have
malfunctioned.
NOTE: Depending on the conditions of use and the
from the actual capacity.
NOTE:
-
Then turn the tool on to restart.
-
is displayed on the pressure gauge. In this situation,
Then, turn the tool on again.
WARNING:
CAUTION:
Otherwise, pulling the switch
Main power switch
To turn on the tool, press the main power switch. To turn
NOTE:
To avoid unintentional start up, the main power switch
will automatically shut down when the switch trigger
is not pulled for a certain period after the main power
switch is turned on.
WARNING: -
WARNING:
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
Switch trigger
1 Overheat warning icon
2
3
4
5
6
Current pressure value
8 Target pressure value
9 Pressure value unit
pressure gauge when you turn on the tool. If nothing is
connected to the tool, the pressure gauge displays “0”.
The pressure gauge also displays the target pressure
the same as the last time.
progress indicator comes to the right end.
To Next Page
Loading...
