17 ENGLISH
2.
1. Screw 2.
3.
1.
CAUTION:
grips during operation.
1.2.3. Depth
pointer 4. Stopper pole setting nut 5. Fast-
6. Stopper pole 7.
8.
1.
2. Turn the stopper pole setting nut counterclock-
the "0" graduation. The depth of cut is indicated on the
3.
4.
5.
6.
7.
attains full speed.
8.
advancing smoothly until the cutting is complete.
When doing edge cutting, the workpiece surface should
1. Workpiece 2.
3. View from the top of the tool 4. Feed
direction
sure to keep it on the right side in the feed direction. This
1. Feed direction 2.
3. Workpiece 4. Straight guide
Moving the tool forward too fast may cause
and mar the cut. The proper feed rate will depend on
Optional accessory
when chamfering or grooving.
1.2. Guide holder 3.
4.5.6. Guide plate
7. Straight guide 8.
1. I
2. Insert the guide holder into the holes in the plunge
3.
Optional accessory
when chamfering or grooving.
Fig.47
1.
1.2. Wing nut 3. Straight guide
2.
the straight guide. At the desired distance, tighten the
wing nuts to secure the straight guide in place.
3. When cutting, move the tool with the straight guide
cutting position is too wide for the straight guide, or if the
side of the workpiece is not straight, the straight guide
to the workpiece and use it as a guide against the router
Fig.49
Optional accessory
The templet guide provides a sleeve through which the
templet patterns.
Fig.50
1.
templet guide and then tighten the screws.
1. Screw 2.3. Templet guide
2. Secure the templet to the workpiece. Place the
tool on the templet and move the tool with the templet
guide sliding along the side of the templet.
1.2.3.
4. Templet 5. Workpiece 6. Templet guide
the following equation:
To Next Page
Loading...
