10
Section 5 Working position
1. Ensure support leg is secured in the raised posi-
tion.
2. Release locking plate and fasten in working po-
sition (see detail below).
3. Open double-action hydraulic cylinder to swing
drawbar into working position.
4. Lower the cutting unit. Ensure the cutter bed
rams are fully extended.
5. When the cutter bed is on the ground, ensure
spool valve for cutter bed rams is in neutral po-
sition.
6. Ensure the tractor lower links are set at 70cm
above ground.
7. Ensure the side covers are in the working position.
8. Adjust swath board for width of swath required.
Locking plate in working position
Set lower links at 70cm from
ground level.
Side covers in their working position
To Next Page
Loading...