15
Procut 2600TC & 3000TC — User Manual
Section 8 Storage
To prepare the mower for storage -
1. Clean the mower of all dirt and debris. Dirt attracts moisture and causes corro-
sion
2. Inspect the mower for worn or damaged parts and replace if necessary.
3. Touch up the paintwork, bare metal must be covered with rust preventative.
4. Drain the oil from the cutter bar and gearboxes, replace with fresh SAE 90 (EP)
oil.
5. Store on a clean dry surface.
6. Loosen the drive belt, or remove and store in dry place.
7. Lubricate all points and slides to prevent corrosion.
8. Jack up the mower to prevent damage to the tyres. Protect the tyres from sun-
shine, grease and oil.
Start-up after storage -
1. Wipe off any excess grease and oil used for protection.
2. Spin the friction clutch to release the friction surfaces if stuck.
3. Check for worn or damaged parts.
4. Run the mower in low/idle rpm speed for a few minutes to ensure all compo-
nents are running smoothly.
Section 9 Spare Parts
Refer to the spare parts manuals for the dedicated models. Always use Malone rec-
ommended parts for optimum performance and longer working life.
To order spare parts or for technical information contact Malone at +353 (0) 94
9360500 or stores@malonefm.com.
To Next Page
Loading...