25
Procut 2600TC & 3000TC — User Manual
Section 11 Troubleshooting
PROBLEM PROBABLE CAUSE
SOLUTION
Poor quality cut Dull or broken blades
Replace blades
Mower not level Adjust machine
Ground speed too fast Reduce speed
Blades locked back Free blades
Blades facing wrong direction Insert blades with arrows facing di-
rection of cut
Streaking or ragged cut Dull or broken blades Replace blades
Ground speed too fast Reduce speed
Excessive cutting height Lower cutting height
Dirt build up between guards Clean bar area between rock guard
at leading edge
Blades facing wrong direction Insert blades with arrows facing di-
rection of cut
Very wet cutting conditions Allow grass to dry
Slow ground speed
Uneven stubble Too much tilt on cutter bar Reduce tilt
Low PTO speed Increase speed to 1000 rpm
Dull or broken blades Replace blades
3-point arms set at wrong angle causing
float mechanism to not function properly
Set 3-point arms
Stubble too long Incorrect angle on cutter bar Change cutter angle
3-point arms set at wrong angle causing
float mechanism to not function properly
Set 3-point arms
Poor Conditioning Conditioner not turning properly Check and adjust belt tension
To Next Page
Loading...