Malossi Force Master 2 - Calibration and Adjustment; Curve Selection and Potentiometer Tuning

ITALIANOENGLISHFRANÇAIS
11
• Adjusting the potentiometer
between these points will
result in adding or subtracting
an amount of fuel proportional
to how far the knob was moved
from zero.
Calibration
• To select the right curve, start
by making sure that all  of
the RPM pots are set to zero
adjustment.
• Then select the base curve
which corresponds to the
vehicle level of modiication.
• This should make the vehicle
run better at all RPMs.
• In case the coniguration/
setting of your vehicle does
not correspond to any of those
indicated in the paragraph
“Working”, it is possible to
get a new tuning adjusting
the potentiometers as above
explained.
WARNING
Do not attempt to adjust while
riding.
We hope you found the above
instructions suiciently clear.
However, if any points are not
particularly clear, please contact
us completing the special
form inserted in the “contact”
section on our Internet site
(malossistore.com). We thank
you in advance for any comments
and suggestions you may wish to
send us. So goodbye from us all
at Malossi, and please accept our
compliments. Have Fun. GOOD
LUCK and … see you next time.
The descriptions in this
publication are not binding.
Malossi reserves the right to make
modiications, if it considers
them necessary, and does not
accept any responsibility for any
typographic or printing errors.
This publication replaces all
previous publications referring to