[Battery check]
1.
Power can be
turned
on/off
with the
small lever beside the shutter release button.
(ON) Align the white dot on the lever with
the white dot on the camera body.
(OFF) Align the white dot on the lever with
the red dot on the camera body.
2.
When the power is turned ON and the
shutter release button is touched slightly,
the shutter speed is indicated on the left
side of the viewfinder and a red LED indi-
cator lights on the upper right side indicating
that power is normal.
*When battery power drops below normal,
or
when the
batteries have been inserted
improperly
,
the
shutter speed does
not
show and the red LED
does not light.
l
When
the
shutter release
button
is lightly touched.
CAUTION:
l Be sure to confirm proper polarity of the bat-
teries before insetting them.
l
D
o
not contaminate the battery surface with oil,
sweat, or other foreign matter. Failure to insert
clean batteries could result in
poor
electrical
contact.
When contaminated, carefully wipe with a dry
cloth, or clean lens tissue.
l
After
the
camera has bean used for many hours
of photographing, or has been inactive for a long
time,
insert
new batteries.
l
When the camera is used in low temperatures,
battery
performance
deteriorates: below
0°C.
34F
use new batteries as needed.
[Spare batteries]
Can be stored inside the body cap.
If
the power
on/off
lever
is left ON, the LED
lights up when the shutter release
button
is
pressed,
resulting
in early battery depletion.
Be
sure
to
keep the
on/off
lever OFF.
1212
To Next Page
Loading...
