•
Taking
Pictures
17
1.
After
focusing
,
turn
the
shutter
speed
ring
(
15
) and
set
the
shutter
speed;
then
adjust
the
aperture
of
the
lens
by
turn-
ing
the
aperture
control
knob
(
18
). Now
the
camera
is
prepared
for
taking
pictures
.
2.
Release
the
shutter
by
pressing
the
shutter
release
button
(7)
or
(19).
When a cable release
is
used, screw
its
tip
into
the
cable release socket
in
the
lower
button
(19).
3.
After
each exposure,
wind
the
film
by
turning
the
film
wind
crank,
then
follow
the
same
routine
as
mentioned
above.
Focusing knob fixing
After adjusting the focus, turn the focusing knob fixing lever (28) for-
ward and appropriately clamp it, wher.eby the focusing mechanism
is
secured.
* Deviation
in
focusing can be prevented
in
this manner, when continu-
ously
taking pictures, taking snapshots with wide-angle lenses, close-
up photograp
hs
,
an
"d using
telephoto
lenses.
How
to
Remove Film
When all film frames have been exposed, the film winding stop mech-
anism
is
automatically released. Remove the film after winding the
remaining
leader paper on the film end.
Winding
Up
the
Roll
Film
To remove film before exposing the entire roll, or to wind up a short
roll
of
film after exposure (6-exposure color films), turn the film wind
crank
while depressing the shutter button on the camera body after
winding the exposed frame.
In
this manner, film can be completely
wound without stopping.
To Next Page
Loading...
