Mamiya ZE-2 - Page 11

~. Installing selector PCB
a. First set the selector to bulb.
(Fig. 5.6)
b. ~hen installing the selector into the
camera body, be extremely careful so
as not to pinch any leadwires ~ith
its fork @.
c. After installing the selector PCB
check it as follows.
1) Set the selector to Auto position
and release the shutter once.
(Fig. 7)
2) Shift the selector to bulb position
again and release the shutter.
Shutter must operate in bulb function.
6. When attaching top cover
a. Set the selector to Auto (Fig. 7)
b. Set the shutter speed dial of the
top cover to Auto and attach it to
tli.e camera body.
Note: It is required to check that
the shutter dial correspond
~ith the selector correctly.
-9-
Bulb position
Fork@
Fig . S
Bulb
position
Fig.6
Auto position
Fig.7