9
10
11
Removing and installing pistons with conrods
114
Fig. 9
Put connecting rod bearing caps in place.
Caution:
The numbers on the conrod bearing cap
and the conrod big end must be on one
side.
Fig. 10
Screw in the conrod bolts and tighten them in sta-
ges to the prescribed value.
Final tightening according to rotation angle me-
thod.
(tightening torques and reusability of bolts, see
“Service Data”)
Fig. 11
Turn the engine slowly.
The conrods and oil injection nozzles (arrow) must
not collide or scuff.
Refit in reverse sequence to the removal proce-
dure all parts previously removed.
To Next Page
Loading...
