M&R Challenger 2 - Replacement Parts; CE vs. UL Models

V.033114
M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA 73
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
8. Replacement Parts
CE vs. UL
Models
All equipment containing electrical components is designed to comply with either Conformance
European (CE) or Underwriters Laboratories (UL) standards, and each type of equipment has a
different parts list. CE equipment runs at 50 Hz; UL equipment runs at 60 Hz. Electrical specifications,
including Hertz, can be found on the Manufacturer’s Rating Plate similar to the one shown below.
Note: You must verify whether your equipment is 50 Hz (CE) or 60 Hz (UL) and order parts accordingly.
DANGER: Operating this equipment with incorrect electrical parts can result in severe or fatal
personal injuries and/or property damage.
Schematic
Diagrams for
Electrical Parts
M&R uses the ‘just-in-time’ approach to printing manuals, so the electrical parts and part numbers
shown in this section should be accurate. However, since schematic diagrams are model -specific,
they remain the most accurate source of electrical part numbers. Cross-reference the part numbers in
this manual with the part numbers in the schematic diagrams in the back of this manual before
placing an order.