3-14
A6 HYDRAULIC OIL LEVEL
CHECK
- Set the lifting platform on a horizontal surface in Transport position with the engine switched
off.
- The oil level should be in the middle of indicator 1 + or - 10 mm (Fig. A6/1).
- If necessary, add oil (see the LUBRICANTS section) via the filling hole 2 (Fig. A6/2).
There may be an oil difference of between 10 and 20 mm between hot and cold oil.
It is advisable to top up the oil when the oil is hot.
A7 CONDITION OF THE JOYSTICK BELLOWS
CHECK
For this operation, climb into the basket when the engine is switched off.
- Check that the joystick’s rubber bellows 1 (Fig. A7) are in good condition by operating them as
if you are making a movement.
The bellows should not show any cracking or fissures: risk of water penetration, which could
impair the machine’s operation.
A8 CONDITION OF THE TYRES & WHEELS
CHECK
- Check the condition of the tyres to discover any cuts, tears or swollen or worn patches, etc. on
the tyres.
A8 SAFE MAN SYSTEM OPTION STATUS
CHECK
Press on the pressure-sensitive edge (Fig, A8/1) and confirm:
> All nacelle movements stop.
>The blue warning light and the audible alarm operate.
>The operation of the nacelle movements when the “OFF” button is pressed once (Fig.8/2).
If the pressure-sensitive edge is defective, the blue warning light flashes faster and a special
alarm sounds. However, the machine can be operated normally.
If the “OFF” rearming button does not work, use the emergency stop to rearm the nacelle.
In the case of malfunction off the option, consult your dealer.
A7
1
1
A6/1
1
A6/2
2
A8/1
A8/2
647414 EN (27/05/2015)
To Next Page
Loading...
