Manitou 160 ATJ E3 - Every 1000 Hours Maintenance

3-34
E  EVERY 1000 HOURS OF OPERATION
E1  FUEL TANK
DRAIN  CLEAN
Never smoke or approach the machine with a naked flame during this operation.
Set the lifting platform on a horizontal surface, rotate the machine 90° (so as to avoid having the
drain plug over the chassis) and switch off the engine.
- Check visually and by touch the parts likely to have leaks in the fuel circuit and the tank.
- In the even of a leak, contact your dealer.
Never attempt to make a weld or any other operation by yourself; this could cause an explosion
or a fire.
- Lay a receptacle under the drain plug 1 (Fig. E1/1) and unscrew the plug.
- Let the diesel flow out and rinse with ten litres of clean diesel poured in through the filling hole
2 (Fig. E1/2).
- Refit and tighten down the drain plug 1 (Fig. E1/1) (tightening torque 3 to 4 daN/m).
- Fill the fuel tank with clean diesel, filtered through a strainer or a clean lint-free cloth and refit
the filling cap (Fig. E1/2).
E2  DRY AIR FILTER SAFETY CARTRIDGE
REPLACE
- Open the left-hand cover.
- Remove the dry air filter cartridge Ref. 1 (Fig. E2/1) (See § D1).
- Remove the dry air filter safety cartridge Ref. 2 (Fig. E2/2) and replace it with a new one.
- Refit the assembly (see § D1).
E1/2
E2/2
2
E2/1
1
E1/1
1
2
647414 EN (27/05/2015)