3-37
E6/2
E6 HYDRAULIC CIRCUIT STRAINER
CLEAN
- Drain the oil (see § D15)
- Remove the hose 2 (Fig. E6/1).
- Unscrew the strainer from the oil bath 1 (Figs. E6/1 and E6/2).
- Clean the strainer with a jet of compressed air.
- Screw the strainer 1 back into the oil bath and refit the hose 2 on the strainer (Fig. E6/1).
- Refill with hydraulic oil (see § D6) (see the LUBRICANTS section).
E7 CONDITION OF THE CYLINDERS LEAKS, RODS
CHECK
- Check the condition of the cylinders. There must be no:
• Hydraulic leaks from the seals and the valve blocks
• Impacts on the cylinder rods
E8 CONDITION OF THE CABLE BUNDLES AND THE CABLES THEMSELVES
CHECK
- Inspect the following sectors, check the condition of the bundles: no deterioration and nothing
loose.
• Base control console,
• Hydraulic block,
• Battery,
• Intermediate joint,
• Basket control console.
E9 ENGINE SILENTBLOCKS *
CHECK
E10 ENGINE SPEEDS *
CHECK
E11 HYDROSTATIC TRANSMISSION CIRCUIT PRESSURES *
CHECK
E12 START OF HYDROSTATIC TRANSMISSION CONTROL *
CHECK ADJUST
E13 MOVEMENT SPEEDS *
CHECK
*(Contact your dealer)
E6/1
1
2
1
647414 EN (27/05/2015)
To Next Page
Loading...
