1
5
MHT 10120 L M
SS
eries
D - Environment.
- A lift truck operating in an area without fire extinguishing equipment must be equipped
with an individual extinguisher. There are optional solutions, consult your agent or
dealer.
- Take into account climatic and atmospheric conditions of the site of utilisation.
For operation under average climatic conditions, i.e. : between -5 °F and 95 °F, cor-
rect levels of lubricants in all the circuits are checked in production. For operation under
more severe climatic conditions, before starting up, it is necessary to drain all the circuits,
then ensure correct levels of lubricants using lubricants properly suited to the relevant
ambient temperatures. It is the same for the cooling liquid.
• Protection against frost (See chapter : LUBRICANTS AND FUEL in paragraph : 3 -
MAINTENANCE).
• Adaptation of lubricants (Ask your dealer for information).
• Engine filtration.
• Lighting (Working headlight).
Optional solutions exist, consult your dealer.
Use of a lift truck is prohibited in protected areas (e.g. refinery, explosive atmosphere).
For use in these areas,specific equipment is available as an option. Consult your dealer.
If necessary, consult your dealer.
R
R
E
E
C
C
O
O
M
M
M
M
E
E
N
N
D
D
A
A
T
T
I
I
O
O
N
N
S
S
F
F
O
O
R
R
U
U
S
S
I
I
N
N
G
G
T
T
H
H
E
E
T
T
R
R
U
U
C
C
K
K
LEVELLING DEVICE :
The machine MHT 10160 L have a device to level the chassis in relation to the
ground, to raise the boom in safety conditions.
This device allows the level to be corrected 10° to the right and to the left 10°.
IMPORTANT
HOW TO USE THIS DEVICE
Use the bubble gauge to level the machine before lifting and telescoping the boom
out.
The levelling operation cannot be carried out when the boom has been raised
more than 30° from the ground. If the machine is not on level, lower the boom
again and repeat the leveling operation.
BEFORE ANY HANDLING WORK, CHECK THAT THE LIFT TRUCK IS
COMPLETELY HORIZONTAL.
Never move the vehicle with the boom raised, with or without load,
as it can overturn; place the load from a height, with the machine stopped