10
1
MHT 10120 L M
SS
eries
H
H
A
A
N
N
D
D
L
L
I
I
N
N
G
G
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
S
S
A - General.
- Check conformity of the accessories to the vehicle safety system calibration
- Ensure the correct functioning of your lift truck’s attachments.
- Do not carry out operations which exceed the capacity of the lift truck or the accessory.
- It is prohibited to increase thecounterweight value in any way.
- It is strictly prohibited to carry or to lift up persons using the lift truck, unless the vehicle
is specially equipped for this purpose and has the corresponding certificate of confor-
mance for lifting people.
- Avoid travelling for a long distance in reverse.
- When lifting or lowering the boom ensure the control lever is moved slowly
and smoothly (whether operating with or without a load).
B - Attachments.
- Ensure that the attachment is correctly fitted and locked to its frame.
- Conform to the limits on the load chart for the attachment.
- Position the forks perpendicular to the load to be lifted, taking account of the load’s
centre of gravity.
- Never lift a load with a single fork.
- Never lift a sling load with a single fork or with the carriage. Optional solutions exist,
consult your dealer.
- If not utilise, place the attachment in horizontal on the ground (For unstable attach-
ments, ensure they are secured using wedges).
- Place the attachments in the closed position, flat on level ground (for unstable attac
ments secure using wedges).
- Ensure that rapid hydraulic connections on the attachment system are clean and pro-
tected.
Carry out the following procedure before changing hydraulic attachments to prevent
damage to the quick release couplings :
- Switch off the engine.
- turn key to position I
- release pressure from the circuit using the joystick
To Next Page
Loading...
