3
31
MHT 10120 L M
Series
G
G
- OCCASIONAL MAINTENANCE
G
G
1
1
- CHANGE A WHEEL
In the event of a wheel being changed on the public highway, make sure of the following points :
- Stop the lift truck, if possible on even and hard ground.
- To pass on stop of lift truck (See chapter : DRIVING INSTRUCTIONS in paragraph : 1 - OPERATING AND
SAFETY INSTRUCTIONS).
- Action the parking brake
- Put the warning lights on.
- Immobilise the lift truck in both directions on the axle opposite to the wheel to be changed.
- Unlock the nuts of the wheel to be changed.
- Place the jack under the flared axle tube, as near as possible to the wheel and adjust the jack (Fig. G1/1).
- Lift the wheel until it comes off the ground and put in place the safety support under the axle (Fig. G1/2).
For this operation, we advise you to use the hydraulic jack and the safety support.
- Completely unscrew the wheel nuts and remove them.
- Free the wheel by reciprocating movements and roll it to the side.
- Slip the new wheel on the wheel hub.
- Refit the nuts by hand, if necessary grease them.
- Tighten the wheel nuts with a torque wrench (See chapter : A - DAILY OR EVERY 10 HOURS SERVICE in
paragraph : 3 - MAINTENANCE for tightening torque).
- Remove the safety support and lower the lift truck with the jack.
Fig. G1
Fig. G1/1
Fig. G1/2
To Next Page
Loading...
