8
1
MHT 10120 L M
SS
eries
Movement instructions.
- Check the transmission oil level.
- Raise the forks or attachment to the transport position approximately 300 mm from the
ground.
- Engage the gear selected (See chapter: CONTROL AND COMMAND INSTRUMENTS
in part: 2 - DESCRIPTION).
- Select the required steering mode.
- Shift the forward/reverse lever to the selected direction of travel.
- Release the parking brake and accelerate gradually until the lift truck moves off.
E - Stopping the lift truck.
Safety notice.
- Before stopping the lift truck after a long working period, leave the I.C. engine idling for
a few moments, to allow the coolant liquid and oil to lower the temperature of the I.C.
engine and transmission.
Ensure you comply wiyh this safety notice as stopping the engine without allowing it to
cool could cause damage to components damaging such parts.
- Never leave the ignition key in the lift truck when the lift truck is unattended.
- When the lift truck is stationary, place the forks or attachment on the ground, place the
gear lever in neutral, apply the parking brake and put the forward / reverse lever in
neutral.
- If the driver has to leave his cab, even for a moment, it is essential to place the gear
lever in neutral, apply the parking brake and put the forward/reverse lever in neutral.
- Make sure that the lift truck is not stopped in any position that will interfere with the
traffic flow and at less than one metre from the track of a railway.
- In the event of prolonged parking on a site, protect the lift truck from bad weather, par-
ticularly from frost (Check the level of antifreeze), close the rear window, lock the cab
door and ensure that the hood is properly secured.
Stop instructions.
- Park the lift truck on flat ground or on an incline lower than 15 %.
- Place the forward/reverse lever in neutral.
- Apply the parking brake.
- Completely retract the boom.
- Lower the forks or attachment to rest on the ground.
- Stop the I.C. engine
- Remove the ignition key.
- Check the closing and locking of door, rear window and hood.
Before leaving your driver's cabin, ensure that you have carried out all operations for
stopping the lift truck, for your safety and the safety of others.
To Next Page
Loading...
Need help?
General