Manitou MLA 628 -120 LSU 3-E2 Series - Page 126

4 - 64 - 6
- Proceed in the reverse order of paragraph HAND LOCKING while making sure you install- Proceed in the reverse order of paragraph HAND LOCKING while making sure you install
the locking pin and the clip in the bracket (fig. A).the locking pin and the clip in the bracket (fig. A).
LAYING AN ATTACHMENTLAYING AN ATTACHMENT
- Proceed in - Proceed in the reverse order of paragraph TAKING UP AN ATTAthe reverse order of paragraph TAKING UP AN ATTACHMENT while making sureCHMENT while making sure
you place the attachment flat on the ground and in closed position.you place the attachment flat on the ground and in closed position.
CC
DD

B - AB - ATTTTACACHMHMENENTT WIWITHTHOUOUTT HYHYDRDRAUAULILICSCS ANANDD HYHYDRDRAUAULILICC LOLOCKCKININGG DEDEVIVICECE((OPTIONOPTION))
MLA 628 -120 LSU POWERSHIFT Series 3-E2MLA 628 -120 LSU POWERSHIFT Series 3-E2
TAKING UP AN ATTACHMENTTAKING UP AN ATTACHMENT
- Ensure that the attachment is oriented for locking to the carriage. If it is not correctly- Ensure that the attachment is oriented for locking to the carriage. If it is not correctly
oriented,oriented, take the necessary precautions in ortake the necessary precautions in order to move it safelyder to move it safely..
- Check that the rods on the locking cylinder are retracted (fig. A).- Check that the rods on the locking cylinder are retracted (fig. A).
- Park the lift truck with the boom lowere- Park the lift truck with the boom lowered in front of and pard in front of and parallel to the attachment,allel to the attachment, tilt thetilt the
carriage forwards (fig. B).carriage forwards (fig. B).
- Bring the - Bring the carriage under the carriage under the locking tube of locking tube of the attachment,the attachment, slightly lift the slightly lift the boom,boom, inclineincline
the carriage backwards in order to position the attachment (fig. C).the carriage backwards in order to position the attachment (fig. C).
- Lift the attachment off the ground to facilitate locking.- Lift the attachment off the ground to facilitate locking.
HYDRAULIC LOCKINGHYDRAULIC LOCKING
- Put the valve in position A (- Put the valve in position A (fig. D),fig. D), the hydraulic circuit of the hydraulic circuit of the attachment locking open.the attachment locking open.
- Switch button 1 (fig. E) of the distributor lever up to completely lock the attachment on- Switch button 1 (fig. E) of the distributor lever up to completely lock the attachment on
the carriage.the carriage.
- Close the valve in p- Close the valve in position B (fig. D),osition B (fig. D), the hydraulic circuit of the athe hydraulic circuit of the attachment locking clo-ttachment locking clo-
sed.sed.
Always close the valve in position B (fig. D) after the locking o
Always close the valve in position B (fig. D) after the locking of the attachment, in order to avoidf the attachment, in order to avoid
AA
BB

Always close the valve in position B (fig. D) after locking the attachment, toAlways close the valve in position B (fig. D) after locking the attachment, to
WARNINGWARNING
CONTENTSCONTENTS
https://www.forkliftpdfmanuals.com/