Manitou MLA 628 -120 LSU 3-E2 Series

To Next Page

To Previous Page

4 - 94 - 9

ments.ments.

Make sure that the rapid connectors are clean and protect the holes which are not used, with

the caps provided.the caps provided.

- Close the valve in p- Close the valve in position B (fig. D),osition B (fig. D), the hydraulic circuit of the athe hydraulic circuit of the attachment locking clo-ttachment locking clo-

sed.sed.

Always close the valve in position B (fig. D) after the locking o

Always close the valve in position B (fig. D) after the locking of the attachment, in order to avoidf the attachment, in order to avoid

accidental unlocking and use the attachment safety.accidental unlocking and use the attachment safety.

HYDRAULIC RELEASING AND HYDRAULIC RELEASING AND DISCONNECTING THE ATTADISCONNECTING THE ATTACHMENTCHMENT

- Close the attachment.- Close the attachment.

- Put the valve in position A (- Put the valve in position A (fig. D),fig. D), the hydraulic circuit of the hydraulic circuit of the attachment locking open.the attachment locking open.

- Switch button 1 (fig. E) of the distributor lever down to completely release the attachment.- Switch button 1 (fig. E) of the distributor lever down to completely release the attachment.

- Stop the I.C. engine and keep the ignition on the lift truck.- Stop the I.C. engine and keep the ignition on the lift truck.

- Release the pressure from the attachment hydraulic circuit by pressing button 1 (fig. E)- Release the pressure from the attachment hydraulic circuit by pressing button 1 (fig. E)

on the distributor lever up and down 4 or 5 times.on the distributor lever up and down 4 or 5 times.

- Disconnect the rapid connectors of the attachment.- Disconnect the rapid connectors of the attachment.

Make sure that the rapid connectors are clean and protect the holes which are not used, with

the caps provided.the caps provided.

LAYING AN ATTACHMENTLAYING AN ATTACHMENT

- Proceed in - Proceed in the reverse order of paragraph TAKING UP AN ATTAthe reverse order of paragraph TAKING UP AN ATTACHMENT while making sureCHMENT while making sure

you place the attachment flat on the ground and in closed position.you place the attachment flat on the ground and in closed position.

Always close the valve in position B (fig. D) after locking the attachment, toAlways close the valve in position B (fig. D) after locking the attachment, to

avoid accidental unlocking!avoid accidental unlocking!

WARNINGWARNING