Manitou MLA 628 -120 LSU 3-E2 Series User Manual

3 - 183 - 18
B8 - CB8 - CAABB VEVENTNTILILATATIOIONN FIFILTLTERER((OPOPTITIONON AAIIRR CONCONDITDITIONIONINGING))
CLEANCLEAN
- Lift up protective casing 1 (fig. B8).- Lift up protective casing 1 (fig. B8).
- Lift out cabin ventilation filter 2 (fig. B8).- Lift out cabin ventilation filter 2 (fig. B8).
- Clean the filter with a compressed air jet.- Clean the filter with a compressed air jet.
- Check its condition and change if necessary (see : 3 - MAINTENANCE : FILTERS CAR-- Check its condition and change if necessary (see : 3 - MAINTENANCE : FILTERS CAR-
TRIDGES AND BELTS).TRIDGES AND BELTS).
- Install the filter and protective casing.- Install the filter and protective casing.
B9 - BB9 - BATATTETERYRY ELELECECTRTROLYOLYTETE LEVLEVELEL
CHECKCHECK
Check the electrolyte level in each cell of the battery.Check the electrolyte level in each cell of the battery.
If the lift truck is working in a hIf the lift truck is working in a high temperature environment,igh temperature environment, check the level more frecheck the level more fre--
quently than every 50 hours service.quently than every 50 hours service.
- Open the I.C. engine cover.- Open the I.C. engine cover.
- Remove caps 1 (fig. B9) from each cell of the battery.- Remove caps 1 (fig. B9) from each cell of the battery.
- The level is correct when it is 1/2 in. above the top of the plates in the battery.- The level is correct when it is 1/2 in. above the top of the plates in the battery.
- If necess- If necessary,ary, top up the cells with clean distilled water that has been stored in a glasstop up the cells with clean distilled water that has been stored in a glass
container.container.
- Clean and dry caps 1 (fig. B9) and install.- Clean and dry caps 1 (fig. B9) and install.
- Check the terminal connections and lightly smear them with petroleum jelly to prevent the- Check the terminal connections and lightly smear them with petroleum jelly to prevent the
formation of corrosion.formation of corrosion.
Handling and servicing a
Handling and servicing a battery can be dangerous, tbattery can be dangerous, take the following precautionsake the following precautions ::
- Wear protective goggles. Keep the battery horizontal.- Wear protective goggles. Keep the battery horizontal.
- Never smoke or work near a naked flame.- Work in a well-ventilated area.- Never smoke or work near a naked flame.- Work in a well-ventilated area.
- In the event of electrolyte being spilled onto the skin or splashed in the eyes,- In the event of electrolyte being spilled onto the skin or splashed in the eyes,
rinse thoroughly with cold water for 15 minutes and call a doctor.rinse thoroughly with cold water for 15 minutes and call a doctor.
B8B8
22
11
B9B9
11
Handling and servicing a battery can be dangerous, take the following precau-Handling and servicing a battery can be dangerous, take the following precau-
titiononss ::
- Wear protective goggles.- Wear protective goggles.
- Keep the battery horizontal.- Keep the battery horizontal.
- Never smoke or work near an open flame.- Never smoke or work near an open flame.
- Work in a well-ventilated area.- Work in a well-ventilated area.
- In the event of electrolyte being spilled onto the skin or splashed in the- In the event of electrolyte being spilled onto the skin or splashed in the
eyes, rinse thoroughly with cold water for 15 minutes and call a doctor.eyes, rinse thoroughly with cold water for 15 minutes and call a doctor.
WARNINGWARNING

B10 - RB10 - REEAARR AAXLXLEE OSCOSCILLILLATIATIONON
GREASEGREASE
Clean and lubricate the points 1 (2 lubricators) (fig. B10) with grease (see : 3 - MAINTE-Clean and lubricate the points 1 (2 lubricators) (fig. B10) with grease (see : 3 - MAINTE-
NANCENANCE : LUBRICANTS : LUBRICANTS AND FUEL) and rAND FUEL) and remove the surplus emove the surplus grease.grease.
B11 - TB11 - TRANRANSMISMISSISSIONON UNIUNIVEVERSRSALAL JOIJOINTNT
GREASEGREASE
Clean and lubricate Clean and lubricate the following points with the following points with grease (see : grease (see : 3 - MAINTENANCE3 - MAINTENANCE : LUBRI-: LUBRI-
CANTS AND FUEL) and remove the surplus grease.CANTS AND FUEL) and remove the surplus grease.
- Remove access panel 1 (fig. B11/1).- Remove access panel 1 (fig. B11/1).
2 - Lubricators of the universal joint Transmission/Front axle (4 lubricators) (fig.2 - Lubricators of the universal joint Transmission/Front axle (4 lubricators) (fig.
B10B10
11
B11/1B11/1
11
CONTENTSCONTENTS
https://www.forkliftpdfmanuals.com/

Manitou MLA 628 -120 LSU 3-E2 Series Specifications

General

Brand	Manitou
Model	MLA 628 -120 LSU 3-E2 Series
Category	Forklifts
Language	English