3 - 173 - 17
B5 - HB5 - HYDYDRARAULULICIC OIOILL LELEVEVELL
CHECKCHECK
Park the lift truck on level ground with the I.CPark the lift truck on level ground with the I.C. engine stopped,. engine stopped, and the boom retracted andand the boom retracted and
lowered as far as possible.lowered as far as possible.
- Refer to gauge 1 (fig. B5).- Refer to gauge 1 (fig. B5).
- The oil level is correct when it is at the level of the red point.- The oil level is correct when it is at the level of the red point.
- If necessa- If necessary,ry, add oil (see : 3 - add oil (see : 3 - MAINTEMAINTENANCENANCE : LUBRIC: LUBRICANTS AND FUEL)ANTS AND FUEL)..
- Remove cap 2 (fig. B5).- Remove cap 2 (fig. B5).
- Add oil by filler port 3 (fig. B5).- Add oil by filler port 3 (fig. B5).
Use a clean funnel and clean the underside of the oil drum before filling.
Use a clean funnel and clean the underside of the oil drum before filling.
- Put the cap back.- Put the cap back.
- Check visually that there is no leakage in the tank and pipes.- Check visually that there is no leakage in the tank and pipes.
Always maintain the oil level at maximum as cooling depends on the oil flowing through the tank.Always maintain the oil level at maximum as cooling depends on the oil flowing through the tank.
22 22
BB44//44 BB44//55 BB44//66
33
44
55
55
55
88
66
99
77
1111
B5B5
11
22
33
Use a clean funnel and clean the oil nozzle before filling.Use a clean funnel and clean the oil nozzle before filling.
IMPORTANTIMPORTANT
B6 - WB6 - WININDSDSCRCREEEENN WAWASHSHERER LILIQUQUIDID LELEVEVELL
CHECKCHECK
- Open the I.C. engine cover.- Open the I.C. engine cover.
- Check visually the level.- Check visually the level.
- If nec- If necessary add windscreen washer essary add windscreen washer liquid (see : 3 - liquid (see : 3 - MAINTENANCEMAINTENANCE : LUBRICANTS AND: LUBRICANTS AND
FUEL) by filler port 1 (fig. B6).FUEL) by filler port 1 (fig. B6).
B7 - CB7 - CAABB DODOOROR
GREASEGREASE
Clean and lubricate the points 1 (4 lubricators) (fig. B7) with grease (see : 3 - MAINTE-Clean and lubricate the points 1 (4 lubricators) (fig. B7) with grease (see : 3 - MAINTE-
NANCENANCE : LUBRICANTS : LUBRICANTS AND FUEL) and rAND FUEL) and remove the surplus emove the surplus grease.grease.
B6B6
B7B7
11
11
11
CONTENTSCONTENTS