2 - 53
4 - COUPLING LADDER (OPTIONAL)
IMPORTANT
Be careful not to get your fingers caught or crushed during this operation.
Do not forget to put the pins and cotter pins back in place.
When uncoupling, make sure that the trailer is independently supported.
COUPLING AND UNCOUPLING THE TRAILER
- To couple the trailer, position the lift truck as close as possible to the trailer ring.
- Apply the handbrake on and switch off the engine.
ON THE FIXED PIN
- Remove pin 1, remove rod 2 and raise latch 3.
- Insert or remove the trailer ring, lower latch 3 and refit rod 2.
ON THE COUPLING LADDER
- Set the coupling fitting 4 according to the height of the trailer ring.
- Remove the clip 5, lift the trailer pin 6 and place or remove the trailer ring.
1
2
3
4
5
6
647449 (30/11/2015)
MT 732/932 ST3B
To Next Page
Loading...
