Manitou MT732ST38 - Description and Use of the Options

2 - 54
DESCRIPTION AND USE OF THE OPTIONS
1 - MODCOD ANTI-THEFT SYSTEM
2 - MODCLE ANTI-START SYSTEM
3 - QUICK-RELEASE COUPLER ON ATTACHMENT CIRCUIT
4 - ENGINE SPEED REGULATOR
5 - ATTACHMENT HYDRAULIC CONTROL FORCED OPERATION
6 - TELESCOPE SUSPENSION
7 - ATTACHMENT EASY HYDRAULIC CONNECTION
8 - BOOM ELECTRICAL PREDISPOSITION
9 - HEAD TELESCOPE ELECTROVALVE
10 - ATTACHMENT HYDRAULIC LOCKING
11 - HEAD TELESCOPE ELECTROVALVE + HYDRAULIC ATTACHMENT LOCKING
12 - EXTERIOR DRAIN-BACK
13 - LIFTING RING ON SINGLE CARRIAGE
14 - ANGULAR SECTOR ON BOOM
1 - MODCOD ANTI-THEFT SYSTEM
OPERATION
- Switch on the lift truck: the red indicator 1 will flash.
- Enter your user code followed by "V" to validate: the green indicator 2 will come on.
- Start the lift truck within the next 60 seconds; otherwise the anti-theft system will
be reactivated and the red indicator 1 will flash.
NOTE: If you make a mistake when entering the code, press key "A" to cancel and re-
enter the code in full. If you wait more than 5 seconds between key presses or
do not complete entering the code, the anti-theft system will be reactivated
and the red indicator will flash.
2 - MODCLE ANTI-START SYSTEM
OPERATION
- Switch on lift truck ignition, red LED 1 will flash.
- Apply key 2 to its base 3, and withdraw the moment the system emits a continuous
beep, and LED 1 turns green.
- Start the lift truck within the next 20 seconds; otherwise the anti-theft system will
be reactivated and red LED 1 will flash.
NOTE: You can restart the lift truck within 20 seconds of stopping it; after this time,
the anti-start system reacts and red LED 1 flashes.
3 - QUICK-RELEASE COUPLER ON ATTACHMENT CIRCUIT
4 - ENGINE SPEED REGULATOR

IMPORTANT

The engine speed regulator cannot under any circumstances be used while driving on the road.
OPERATION
- Turn button 1 to increase or reduce the engine speed, and thus control the hydraulic
flow within the attachment circuit.
- View the rev. counter to adjust the engine speed.
- Return the engine to idle before switching off the lift truck's ignition.
2
1
1
647449 (30/11/2015) MT 732/932 ST3B