Manitou MT732ST38 - Servicing Schedule

3 - 8
SERVICING SCHEDULE

IMPORTANT

(1): MANDATORY 500 HOUR OR 6 MONTH SERVICE. This service must be carried out after approximately the first 500 hours of operation or within the 6 months following
the start-up of the machine (whichever occurs first).
(2): Every 10 hours during the first 50 hours then a final time at 250 hours.
(3): Contact your dealer.
A = ADJUST, C = CHECK, G = GREASE, N = CLEAN,
P = BLEED, R = REPLACE, V = DRAIN
PAGE (1)
DAILY OR EVERY 10
HOURS OF SERVICE
EVERY 50 HOURS
OF SERVICE
EVERY 250 HOURS
OF SERVICE
EVERY 500 HOURS
OF SERVICE
OR EVERY YEAR
EVERY 1000 HOURS
OF SERVICE OR
EVERY TWO YEARS
EVERY 2000 HOURS
OF SERVICE OR
EVERY TWO YEARS
EVERY 3000 HOURS
OF SERVICE
EVERY 4000 HOURS
OF SERVICE
OCCASIONALLY
ENGINE
- Engine oil level 3-10 C
- Cooling liquid level 3-10 C C
- Fuel level 3-10 C C
-
Fuel pre-filt
er 3-11 C
- Cyclonic pre-filter 3-11 N N
- Dry air filter cartridge 3-14/26 R C/N R
-
Radiator co
res 3-14 N N
- Engine oil 3-22 V V
- Engine oil filter 3-22 R R
- Fuel pre-filter cartridge 3-26 R R
- Fuel filter cartridge 3-27 R R
- Fuel tank 3-27 N
- Fuel tank breather 3-27 R
- I.C. engine silent blocks C (3)
- I.C. engine rates C (3)
- Valves clearances C C (3)
- Cooling liquid 3-30 V
- Safety dry air filter cartridge 3-31 R
- Radiator C (3)
- Water pump and the thermostat C (3)
- Alternator and the starter motor C (3)
- Turbocompressor C (3)
- Alternator belt 3-33 R
- Compressor belt (Air conditioning OPTION) R (3)
TRANSMISSION
- Gear box oil level 3-15 C
- Angle gear box oil level 3-20 C
- Gear box oil filter 3-23 R R
- Gear box oil 3-28 V V
- G
ear box sump strainer 3-28 N N
-
Angle gear box oil 3-29 V V
- Silentblocks in the gear box C (3)
- Gear box controls C (3)
- Transmission pressures C (3)
- Wear of the brake pads and the brake disk C (3)
TYRES
- Tyre pressures 3-15 C C
- Wheel nut torques 3-15 C C
- Wheel nut tightening tor
que 3-31 C C
- Wheel 3-34 R
BOOM
- Boom pads 3-11 N/G (2)
- Boom 3-16 G G
- Boom pad wear C (3)
- C
ondition of boom unit C C (3)
- Bearings and articulation rings C (3)
HYDRAULICS
- Hydraulic oil level 3-17 C C
- Hydraulic return oil filter cartridge 3-23 R R
- Hydraulic oil 3-23/31 C V
- Suc
tion strainer for hydraulic oil tank 3-31 R
- Hydraulic oil tank 3-31 N
- Filter cap for hydraulic oil tank
3-31 R
- Distributor control head filter
3-31 R
- Condition of hoses and flexible pipes C (3)
- Condition of cylinders (leakage, shafts) C (3)
647449 (30/11/2015) MT 732/932 ST3B